Shear Past Questions
REINFORCED CONCRETE DESIGN 2-2012-2018
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: STE518
Topics: column, beam, floor, shear, deflection, reinforcement, retaining wall, punching shear, yield line method, flat slab, slab, cantilever, dead load, preliminary design, bearing pressure analysis, stem wall design, stem wall reinforcement, axial load, unaxial moment, slender column
Year: 2019
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ACE308
Topics: Structures theory, truss, truss parameters, trusses analysis, warren steel truss, bending moment, radial shear, normal thrust, Warren steel truss, horizontal deflection, maximum shear
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: PET415
Topics: Petroleum rock mechanics, isotropic rock, anisotropic rock, rock dynamic properties, shear modulus, young's modulus, elastic region, yield point, chip hold down, uniaxial compressive strength, ductile region, brittle region, shear failure, hydro pressure, abnormal formation pore pressure, overburden pressure
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: STE505
Topics: grade 275 steel, flange, block shear, plate tension capacity, bolt bearing
Strength of materials 2016,2017
Year: 2017
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG305
Topics: Shear stress, force, load, normal stress, stress, factor of safety, modulus of elasticity, modulus of rigidity, mohr's circle, beams, cantilever, deflection, deformation, flexural rigidity, columns
Fluid mechanics 2013,2014&2015
Year: 2015
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG309
Topics: pressure, free surface, Reynolds number, bulk modulus, turbulent flow, steady flow, cavitation, shear, orfice, kinetic energy, potential flow, incompressibility of fluid
MACHINE DESIGN 1-2016,2017,2019
Year: 2019
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG311
Topics: torsional stress, shaft, shear stress, screw jack, joint, pitch, clearance, interference, transition
Year: 2018
School: Federal University of Technology, Owerri
Department: Medical, Pharmaceutical and Health science
Course Code: OPT510
Topics: phoropter, AC/A ratio, duochrome chart, prism, foria, myope, hyperope, anieseikonia, percevial, sheard, accommodation
POLYMER RHEOLOGY 1-2012,2015,2016,2017,2018,2019
Year: 2019
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: PTE411
Topics: Rheology, Maxwell element, Voight-Kelvin Element, Newtonian fluid, viscoelastic, shear
Mechanics and Properties of Matter-2001-2003,2005,2006
Year: 2006
School: University of Ibadan
Department: Science and Technology
Course Code: PHY114
Topics: stress, strain, Young's modulus, shear modulus, Bulk modulus, work, force, Newton's law, parallel axis theorem, projectile, simple harmonic motion, inclined plane, motion on a plane, dimension analysis, Kepler's law, synchronous orbit, rigid body, physical quantity, acceleration due to gravity
Departments
Administration, Social and Management science
Agriculture and Veterinary Medicine
Arts and Humanities
Education
Engineering
General studies
Law
Medical, Pharmaceutical and Health science
Science and Technology